If you have a helper a table saw is ideal.
Cutting vinyl lattice with hand saw.
A fine blade back saw much like what s used in a miter box.
I had to replace a couple vinyl lattice sections that w.
You can also use a trim saw or a handsaw.
Set the blade depth 0 5 in 1 3 cm wider than the lattice s thickness.
Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade.
Cut correctly be sure the lattice face side is upward when a fine toothed hard saw is in use.
If necessary walk on the lattice to the side of the lumber opposite the saw and marked line.
Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood.
If you plan to make angled or curved cuts use a power saber saw.
To cut vinyl lattice attach a vinyl cutting blade to the power saw.
Have your helper assist you in guiding.
This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you.
In case you have to do a lot of cutting in straight lines with the plastic lattice the circular saw or power saw with the plastic cutting blade is your best option.
Adjust the blade depth on a circular saw by releasing the blade lever on the back.
Start by cutting your vinyl lattice.
Hold the saw against the lattice as if you were about to cut it then let the blade dip roughly 0 5 in 1 3 cm below the level of the lattice.
Ease the saw or blade carefully through the lattice.
The best way to cut vinyl lattice is to use a circular saw and a cutting blade.
Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line.
The width depth of the blade may offer a bit more straight.
The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through.
If you don t have a vinyl cutting blade you can use another fine toothed blade.
Some are sold without the support spine allowing no angleing as you cut.
Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade.
